Full-time | 1st Shift (1 opening) · 2nd Shift (2 openings) We are hiring 3 Aluminum Die Cast Process Techs: 1 on 1st shift and 2 on 2nd shift. #### Job Summary Operate the die cast machine and monitor the die cast process to produce quality castings as a member of the die cast cell. #### Machine Operation & Setup - Start up and shut down all equipment in the die cast area - Set all required dies and have 1st pieces ready for production - Remove castings from the die and place them on the conveyor - Lubricate the die and cores as required - Clear the die of any excess debris or flash - Monitor the press to make sure castings keep being produced - Read the Visi-Trak monitor and make changes as needed - Operate the machine in a safe and responsible manner - Never place hands or any part of the body in the press while the safety mechanisms are not in place - Perform and record safety checks on the cast press machine #### Quality & Documentation - Review job materials at the work station for the job running - Complete the Die Cast Process Tech Checklist - Review and update all process documentation - Know the Die Cast Flow Chart - Visually inspect raw castings for defects on an ongoing basis and complete checks per the process book - Recognize die-casting defects in critical areas of parts - Ensure quality parts are produced; strive to improve quality and continually increase production - Sort and rework trimmed die cast parts as needed - Complete required production paperwork (uptime, production logs, scrap, etc.) and other forms as directed by your supervisor #### Teamwork & Safety - Contact quality or your supervisor with questions or concerns, and report any problems or possible problems - Take an active part in all die cast cell activities and all training, especially training on new technology or processes - Keep the work area clean - Perform all job duties with safety and quality as the primary focus (see the employee handbook and the PPE "Personal Protection Equipment" Matrix posted in each plant) - Help in other areas and perform other duties as assigned by your supervisor #### Qualifications - Working knowledge of die cast and trim press set-up processes - Mechanically inclined, able to use most hand tools and some power tools - Must be able to lift 40 lbs. from floor to waist