UDV / HW Design Verification Engineer | On-site role.

Job Title: UDV / HW Design Verification Engineer

Location: Dallas, Texas, USA (On-site)

Experience: 5–8 Years

Preferred Qualification: Bachelor’s or Master’s in Electronics / Electrical / RF Engineering or related field

Job Description:

We are looking for an experienced UDV / HW Design Verification Engineer to work on-site at the Dallas R&D Lab. You will plan and run hardware verification on units, find and analyze issues, and report results to the engineering teams.

Key Responsibilities:

• Create the verification plan from product and design requirements
• Define test scope, test cases, test methods and acceptance criteria
• Set up the test environment and operate measurement equipment
• Perform unit bring-up and functional verification
• Verify RF and electrical performance, including operating and corner conditions
• Analyze results, run regression tests, isolate faults and find root causes
• Report defects in and verify corrective actions
• Prepare verification reports and release readiness evidence; support factory if needed
• Maintain requirement-to-test traceability and test coverage

Required Skills & Experience:

• Hands-on experience in hardware / unit design verification
• Strong knowledge of RF and electrical measurements and lab instruments
• Experience in test planning, test case design and test automation
• Skilled in debugging, fault isolation and root-cause analysis
• Experience with verification reports and defect tracking
• Experience with Python or similar scripting for test automation
• Knowledge of PA / RF radio hardware
• Good communication and documentation skills

Work Location & Travel:

• Dallas R&D Lab – on-site presence required for lab and design work.