Electronic Manufacturing Technician

Electrical/Electronics Manufacturing Technician

Key Responsibilities

• Assemble control panels, backplates, and enclosures following schematics, wiring diagrams, and layout drawings
• Install and mount components such as breakers, relays, contactors, PLCs, power supplies, terminal blocks, and hardware
• Route, cut, strip, crimp, and terminate wires according to wiring standards. Maintain clean and organized wiring paths and panel layouts
• Label wires, components, and enclosures accurately
• Soldering & PCB Assembly - Through-hole and surface-mount soldering, rework, and inspection to IPC standards.
• Use hand tools, power tools, and torque tools safely and correctly
• Wiring & Harness Fabrication - Building cable assemblies, connectors, DMX cabling, power harnesses, and fixture wiring.
• Component Identification - Resistors, capacitors, ICs, LEDs, drivers, MOSFETs, microcontrollers, etc.
• Firmware loading and basic microcontroller programming
• Perform point-to-point wiring checks and continuity testing
• Testing & Troubleshooting - Using multimeters, scopes, and test fixtures to verify electrical performance and to diagnose failures.
• Document work performed and report issues or discrepancies to engineering or supervisors
• Maintain a safe, clean, and efficient work environment
• Ability to perform power-up testing

Required Skills & Qualifications

• Experience in electrical assembly, wiring, or control panel building
• Ability to read and interpret electrical schematics, wiring diagrams, and BOMs
• Proficiency with wire crimping, terminating, and cable management
• Familiarity with hand tools, power tools, and electrical test equipment
• Ability to drill, tap, cut, and mount components on backplates or enclosures
• Ability to perform continuity checks and point-to-point verification
• Soldering experience (through hole or surface mount).
• Experience with multimeters and basic electrical test equipment
• Ability to perform power-up testing
• Understanding of functional testing procedures and documentation
• Strong attention to detail and craftsmanship
• Ability to follow instructions and work independently or as part of a team

Physical Requirements

• Ability to stand or sit for extended periods
• Ability to lift up to 30 lbs as needed
• Good manual dexterity and hand-eye coordination