Tubemill Operator 2nd shift

Please visit our website at https://www.huskyrackandwire.com/careers and complete our online application to be considered for any of our open positions. Hours: Monday thru Thursday 3:30pm to 2:00am with mandatory OT on Fridays and Saturdays based on a business need. Pay rate: $20.67 to $22.17 +10% shift differential +-----------------------------------------------------------------------+ | Job Summary | | Perform a variety of duties to set up, adjust, change over, operate | | and maintain tube mill to roll form and seam weld continuous tube to | | specifications for a variety of sizes and standard lengths. | | | | | | | | Essential Requirements | | | | | | | | 1. Able to read a ruler and understand fractions | | 2. Welding experience preferred | | 3. Prior manufacturing experience | | | | Essential Job Functions | | | | 1. Set up machine for a variety of sizes of tube. Remove and replace | | rolls, make up shims for proper roll spacing and alignment. Use | | vernier caliper to make up sets of shims to required thickness. | | Assemble bearing blocks and nuts and maintain tightness of nuts. Set | | and adjust cutoff dies as required. | | | | 2. Load coil of steel onto unreeling machine using overhead electric | | hoist and chain. Use helper to line up coil and swing to position for | | loading. Shear tail end of preceding coil in hydraulic shear to | | square end and dispose of damaged end of coil. Advance preceding | | material to weld station and shear beginning end of new coil for | | squareness. Advance to butt with other coil and free hand Mig weld | | butt joint, joining two coils. Grind top and bottom of butt joint | | with disk sander to remove weld bead and spatter. Join butt weld | | through rolls and then start automatic continuous rolling. | | | | 3. Set automatic cut off at console for desired beam length and | | check length of cut off pieces with tape measure. | | | | 4. Mix and add water and water soluble coolant as required and add | | distilled water to resistance weld cooling system as necessary. | | | | 5. Monitor resistance welding station on mill and make necessary | | adjustments to assure quality weld. | | | | 6. Perform various measurements and inspections on finished product | | to ensure specifications are met. | | | | 7. Work from schedule sheet, make out production tags for each lot | | and maintain daily log of production, down time and machine problems. | | | | 8. Ch nge broken or damaged rolls; perform other minor maintenance | | as required. | | | | 9. Operate lift truck to position coils, move and store banded | | bundles of beams. | | | | 10. Train, instruct, assign and check work of lower level operator | | in set ups, change overs, adjustments, and tube mill operation. | | | | 11. Detect and report any material defects, major equipment | | malfunctions, other problems to the supervisor. Maintain equipment | | and work area in a clean and orderly condition. Follow all safety | | rules, regulations and practices. | | | | Perform other similar or related duties as assigned or instructed. | | | | Evaluated Revised Audited Revised | | | | AHS 9/85 AHS 7/92 RGM 5/97 RGM 10/15 | | | | The description above represents the most significant duties of this | | position but does not exclude other occasional work assignments not | | mentioned, the inclusion of which would be in conformity with the | | factor degrees assigned. | +-----------------------------------------------------------------------+